×
Notice
The forum is in read only mode.
Forum
Telephony Cards Support
B100/200/400/800 Series
How to connect (wire) B100P to the ISDN line?
×
Questions about B100/200/400/800 ISDN BRI Cards
How to connect (wire) B100P to the ISDN line?
13 years 11 months ago #5555
by acim
I found some pin specification
here
.
[attach]174[/attach]
But, I still don't know do I connect to NT Box Intracom netMod+? It looks like that because of 4 wires, but then do I set NT or TE mode on the card?
Sorry for these newbie questions
13 years 11 months ago #5556
by acim
I found something more
here
. It seems to me I need to use TE mode and connect to port S0 to the NT box. And this seems to be the wiring scheme:
Please confirm this is correct.
13 years 11 months ago #5557
by acim
One even better wiring scheme:
13 years 11 months ago #5559
by Joe.Yung
Hello,
The ISDN BRI requires an RJ-45 straight through cable. And the pins should be like as your description of the third post above. Pins 1,2,7 and 8 are not used.
13 years 11 months ago #5565
by acim
I made cable like you can see on the network tester here:
[attach]181[/attach]
and followed
these instructions
. But, I always get link down message. Here is my Intracom netMod box with switches and connections:
[attach]183[/attach]
[attach]182[/attach]
I've tried many jumper combination with no success.
My B100P card jumpers are SW1 to the right (TE) and I've tried SW2 both opened and closed, but it didn't help.
Here are information from Asterisk console:
[attach]184[/attach]
[attach]185[/attach]
i] Last edited by acim at 2010-5-8 17:58 [/i
13 years 11 months ago #5567
by acim
I finally found what was wrong. First, I changed cable to normal, straight ethernet cable and second, link is always down unless you call the ISDN number, then it comes up:)
Thank you!
Forum
Telephony Cards Support
B100/200/400/800 Series
How to connect (wire) B100P to the ISDN line?
Time to create page: 0.050 seconds